Edison weather station: enclosures for sensor modules are ready

Just a quick update on sensor modules. I’ve prepared two out of four sensor modules with enclosures and sensors attached.

See below for photos, but general idea is simple – sensor on the outside, attached by a drop of glue from a glue gun, Arduino 101 inside connected by standard male-to-female cables. I had to solder pins extracted from a single row male pin header to DHT-22’s pins, otherwise they were too short on the underside, other than that that was an easy task.

The enclosures are really nice and 101s fit there nicely, leaving some space should I need to add something. These are Arduino original enclosures produced by arduino.org.

101 and sensor part from the top

101 and sensor part from the bottom

Two fully assembled enclosures

Leave a Reply

Your email address will not be published.